Hey people!

Our project is going on! We had couple meetings and figured out the final idea of the project. So, the main part - drill - will be designed and print in the SolidWorks. The DC motor will be attached to the drill, so it will pump the water from the bottom reservoir up to the top. The potentiometer will control the speed of the DC motor. Also, LCD display will display the speed of rotation of the drill. And finally, the Servo motor will be attached to the top cup (reservoir) and flip it, so the water goes back to the bottom reservoir, when the button is pushed!

During the meetings this week we spent about one hour brainstorming.

Have fun! Peace

Hey people!

This is a BBteam with a Archimed's drill project.

Hopefully, you are doing good, and we will try to surprise you in our every post over.

Here is a our projected result, which we will design by SolidWorks 2013, print out model with a 3D printer and use Arduino Board to demonstrate the motion.

Peace:)